• Welcome to AlpineZone, the largest online community of skiers and snowboarders in the Northeast!

    You may have to REGISTER before you can post. Registering is FREE, gets rid of the majority of advertisements, and lets you participate in giveaways and other AlpineZone events!

Heat Molding at Home

prsboogie

Active member
Joined
Aug 13, 2014
Messages
1,764
Points
38
Location
Swansea
Has anyone baked their liners at home to mold them? If so, what temp and for how long? Any ideas for increasing the volume of the toe box? Any helpful hints would be appreciated.
 

deadheadskier

Moderator
Staff member
Moderator
Joined
Mar 6, 2005
Messages
27,921
Points
113
Location
Southeast NH
Did you not buy your F2s in a shop?

I would think they'd re-bake them for you. When I didn't have sufficient toe box room in my Krypton's, Richelson's re-baked them for me with this toe cap piece over my toes and under the sock.
 

prsboogie

Active member
Joined
Aug 13, 2014
Messages
1,764
Points
38
Location
Swansea
I got them online. I know intuition has a fit kit they sell with their liners that includes a toe cap but I'm not sure what to use if I do this at home. I checked you tube but was wondering if anyone on here has done it
 

Puck it

Well-known member
Joined
Oct 26, 2006
Messages
9,681
Points
48
Location
Franconia, NH
Set oven to 150. Let it get to temp then turn off. Put liners in for 10 minutes and the take out and put them on in the shells.
 
Top