Top delamination

[dvto2]

I tried to epoxy my ski top which was coming up right in front of the binding. I used an underwater flexible epoxy (see pic) but it did not hold. It was hard to get the expoxy very deep under the top as it’s a small crack. Would I do better with a better epoxy? Any suggestions for hearing getting more epoxy into the crack?

 

[Smellytele]

Did you clamp it down after getting the epoxy in?

 

[dvto2]

Yes.

 

[Smellytele]

It may be best to actually remove the binding which may give you more flexibility of the top sheet to get the epoxy under it.
Another more radical option is remove the binding then cut the top sheet to lift it up, epoxy it, then put the binding back on.

 

[dvto2]

Got you. I went out again today and did a bit more delamination so the space is a bit wider. I’ll try again with the west marine epoxy. Thanks for the thoughts.