John9
Member
- Joined
- Feb 7, 2018
- Messages
- 100
- Points
- 18
Have instaprint footbeds from current boots, moving to new boots for next season. The beds fit fine except they seem too thick. Foot sitting too high in the boot, pressure on instep and heel not fully down in pocket.
The bottom material of the bed is easy to sand down with sand paper. Seems like a simple enough DIY job. Anyone do this before? Anything to watch out for besides not canting the bed base?
The bottom material of the bed is easy to sand down with sand paper. Seems like a simple enough DIY job. Anyone do this before? Anything to watch out for besides not canting the bed base?